MANUAL
|
13 |
CONTROLS ON THE HANDLEBAR
CONTROLS ON THE HANDLEBAR
SET SPEED LIMIT
• Switch off the scooter (on/off switch)
• Press and hold thumb brake
• Switch on the scooter (on/off switch)
• L1” appears in the display
• Use the [LIGHT] button L1-L2-L3-L4 to switch to the menu
L1 = Limitation of the speed to 6 km/h
L2 = Limitation of the speed to 20 km/h
L3 = Limitation of speed to 25 km/h
L4 = Max. Speed
• To set up a new speed limit, press the [SET] key.
• To exit the settings, release the thumb brake.
%
ERROR CODE
E1: Overcurrent protection (motor does not move for more
than 4 seconds) - this error disappears when you release the
throttle lever.
E2/E4: Communication error (no communication for more
than 400ms) - this error clears when connection
is restored. Connection is established again.
E3: Overvoltage error (battery voltage too high).
Replace original battery, other hardware problems.
Black screen:It was too long in the sun. Please put it out of the sun for a while!
The display will be restored.
KICK START
• Switch on the scooter (on/off switch)
• Press and hold the thumb brake
• Press the on/off switch
• The display shows P1
• To turn the kick start function on or off, press [SET]
• To exit the settings, release the thumb brake.