k) Selecting access mode
There are several options for activating the changeover contact (relay) of the code lock:
•
Activating the changeover contact with the user transponder
Hold a transponder in front of the sensor surface. If a valid transponder has been detected
by the code lock, the changeover contact will be activated.
The changeover contact cannot be activated with fingerprints stored in the code lock.
•
Activating the changeover contact only via the user fingerprint
Hold your finger on the fingerprint sensor. If a valid fingerprint has been detected by the
code lock, the changeover contact will be activated.
The changeover contact cannot be activated with transponders stored in the code lock.
•
Activating the changeover contact via user fingerprint
or user transponder (default
setting)
Hold a transponder in front of the sensor surface or
place your finger on the fingerprint
sensor. If the transponder or the fingerprint is valid, the changeover contact will be acti
-
vated.
•
Activating the changeover contact with a certain number of user fingerprints
or
user transponders
The changeover contact is only activated when multiple valid access attempts have been
carried out using different
fingerprints/transponders one after the other. The number of
valid access attempts is adjustable (2....9).
Example: Two access attempts are programmed.
If the code lock detects the first valid access attempt (user fingerprint or transponder), the
control LED will flash green for approx. four seconds. During this time, another valid ac
-
cess attempt by another fingerprint/transponder is required. The changeover contact will
only be activated after these two valid access attempts.
This ensures a higher level of security because, for example, a transponder card and then
a fingerprint are required to activate the changeover contact.
45