Resetting and tuning-in two transponder cards:
•
Disconnect the code lock from the voltage/power supply. Wait until the control LED goes
off.
•
Keep the door opener button pressed and connect the code lock to the voltage/power
supply.
•
The code lock will emit two beeps, and the control LED will light up orange. Then release
the door opener button.
•
You now have approx. ten seconds (orange LED lights up) to tune-in two transponders.
Hold two transponders in front of the code lock, one after the other.
The first transponder is the one new transponders can be tuned-in with (= “Master Add
Card”).
The second transponder is the one with which tuned-in transponders can be deleted
(= “Master Delete Card”).
• After the second transponder has been tuned-in, the control LED lights up green briefly
and then glows red steadily, the reset has been completed, the code lock is in standby
mode and ready for use.
Resetting without tuning-in two transponder cards:
•
Disconnect the code lock from the voltage/power supply. Wait until the control LED goes
off.
•
Keep the door opener button pressed and connect the code lock to the voltage/power
supply.
•
The code lock will emit two beeps, and the control LED will light up orange. Keep the door
opener button pressed and do not release it.
•
After approx. ten seconds, the code lock will emit a long beep and the control LED will light
up green. Now release the door opener button.
51