Sygonix 2380477, Operating Instructions Manual

18

d) Deleting individual user transponders

The respective user will no longer have access once the corresponding user transponder has been deleted. User 
transponders can be deleted via the user transponder, the transponder number or the memory cell number.

User transponders can also be deleted with the master transponder. 

1) Deleting a user transponder with the IR remote control

•  Enable the programming mode as described in section 8. a); the LED starts to flash red.
• 

Enter the programming code   to delete the transponders. The yellow LED will then light up.

• 

Transponders can be deleted in three different ways:

- Hold the user transponder once in front of the RFID sensor. Once the transponder is recognised, the access 

system emits a short beep and the transponder is deleted. 

- If the transponder is defective or lost, enter its 8- or 10-digit transponder number and press the   button to 

confirm. 

-  Enter the memory cell number of the user transponder (without leading zeros, e.g.    ) and press the   button 

to confirm. 

Other user transponders can be deleted as described here above.

  When the system does not recognise the user transponder and, hence, it cannot be deleted (or the entered 

memory cell number is already empty), the access system will emit 3 brief beeps and the LED will flash red. 

• 

Press the 

 button to exit the delete mode. The LED flashes red again, which means that you can continue pro

-

gramming or exit the programming mode with the   button. 

2) Deleting a user transponder with the master transponder

• 

Hold the master transponder twice in a row in front of the RFID sensor. The access system will emit a short beep 
and the yellow LED will light up.

• 

Hold a user transponder once in front of the RFID sensor. Once a signed up user transponder is recognised, the 
access system emits a short beep and the user transponder is deleted.

Optionally, it is also possible to delete a user transponder by entering its 8- or 10-digit transponder number and 
pressing the 

 button for confirmation. 

  When the user transponder is unknown and/or already deleted, the access system emits three brief beeps 

and the LED flashes red. 

• 

Other user transponders can be deleted by following the instructions above.

•  Hold the master transponder in front of the RFID sensor to finish the deletion process. The red LED will then light 

up and the access system will go back to standby mode.