k) Setting the changeover contact activation time
This function enables to set the changeover contact activation time from 01 to 99 seconds after
a valid access to the code lock (default setting is 5 seconds).
When “00” is set, the changeover contact goes to “toggle” mode. Each valid access to the code
lock changes the changeover contact switch position. This can be used to enable/disable an
alarm system.
Proceed as follows:
•
Enter the master code twice to start the programming mode, as described in section 8. a).
The yellow LED must light up.
•
Enter the programming code for the activation time:
•
The code lock will emit 2 beeps.
•
Enter the desired changeover contact activation time.
Example 1: Activation time is 8 seconds:
Example 2: Toggle mode:
•
The code lock will emit a long beep.
•
Other settings can now be made, if desired. Press the button to exit the programming
mode.
Example 1 for a 3-second activation time (first start programming mode, see section 8. a):
Example 2 for toggle mode (first start programming mode, see section 8. a):
If the door is equipped with a door contact such as a magnetic/reed switch, refer to
section 7.
61
