Sykes-Pickavant Ltd, Unit 4 Cannel Road, Burntwood Business Park, Burntwood, Staffordshire, WS7 3FU.
United Kingdom
Tel: +44 (0) 1543 679900 Fax: +44 (0) 1543 679901
e-mail: sales@sykes-pickavant.com www.sykes-pickavant.com
COPYRIGHT 2018 - SYKES-PICKAVANT LTD. ALL RIGHTS RESERVED. ALL PRODUCTS SUBJECT TO AVAILABILITY. E&OE.
4.
Access the vehicle battery and connect the crocodile clips on the
machine onto the battery. The RED clamp needs to be connected to
the positive battery terminal, and the BLACK clamp needs to be
connected to the negative terminal. Incorrect connection will blow
the fuse.
5. Turn
the car engine back on. Switch the cleaning machine on - a
blue internal light indicates that the machine is on and functioning.
6. Insert HHO hose into a small container of water to check Hydrogen
is being produced (i.e. bubbles).
7.
Insert HHO hose into the vehicle’s air induction inlet and where
possible before air flow sensor.
8. Run
the vehicle at tick over up to 60 minutes. Every 10 minutes,
apply fast full throttle usage at the same time, in order to allow the
engine to clear out any loosened carbon deposits.
9.
At the end of the process, switch the cleaning machine off and run
the vehicle’s engine for a further 2 minutes or more, to use up all
the hydrogen gas which may be in the delivery hose. Switch off
engine and disconnect the battery clamps. Remove the HHO hose,
refit the vehicle air inlet and test.
Specialist Tool Solutions