1 Press SETUP to display SETUP menu.
Screen:
Remote:
2 Select CHANNEL using navigation
buttons
o
o
/
p
p
, then press ENTER.
•
CHANNEL menu appears.
3 Select AUTOSCAN using navigation
buttons
o
o
/
p
p
, then press ENTER.
•
AUTOSCAN menu appears.
4 Select AUTOSCAN or EXTENDED
SCAN using navigation buttons
o
o
/
p
p
,
then press ENTER.
•
The Scanning screen appears while the STB scans for
available digital channels and adds them to the channel
map.
TIP:
When you want to completely reflesh the channel
map, use ADD/DELETE to delete all the channels,
then do the AUTOSCAN again.
See “Deleting channels” on page 36 for details.
To cancel during scanning:
Press SETUP or ENTER.
•
AUTOSCAN CANCELLED appears on the screen.
NOTE:
If cancelled, some channels not yet scanned may not
be received. We recommend completing
AUTOSCAN or EXTENDED SCAN.
5 Scan is completed.
•
SETUP menu goes off automatically and STB starts
receiving broadcasts.
Press CH
o
/
p
buttons to verify whether STB is
receiving channels being broadcast.
When NO SIGNAL appears on the screen:
Verify the antenna connection, then scan again.
The STB tunes in channel 2-1 and NO SIGNAL
appears if the STB could not receive any channels.
2-1
NO SIGNAL
7-1
State of the union
MONAURAL
AUTOSCAN COMPLETED
AUTOSCAN
QUIT
Now the system is scanning for channels.
100%
Channel Found
2-1
AUTOSCAN CANCELLED
or
AUTOSCAN
QUIT
Now the system is scanning for channels.
Autoscan
Extended scan
Takes about 3 minutes.
Takes about 20 minutes.
11%
Channel Found
EXTENDED SCAN
QUIT
Now the system is scanning for channels.
Remaining Time:
11%
18min
Channel Found
AUTOSCAN
QUIT
CHANNEL
DISPLAY
CLOCK
DETAIL
(approx 20min)
AUTOSCAN
EXTENDED SCAN
CHANNEL
QUIT
CHANNEL
DISPLAY
CLOCK
DETAIL
ADD/DELETE
ANTENNA
AUTOSCAN
SETUP
QUIT
CHANNEL
DISPLAY
CLOCK
DETAIL
40
EN
1A23
Advanced Operation
ST300UA.qxd 04.8.3 1:12 PM Page 40
