Sylvania D6313CB, Owner'S Manual

- 11 -

EN

0B19

SET UP FOR USE

You can program the tuner to scan all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just
select the TV/VCR channel selector to the output channel of the cable box or satellite box (Ex CH3). Then
select the channel to be viewed on the Cable Box or Satellite Box.

1

Plug in the TV/VCR power cord

Attach the smaller end of the sup-
plied AC cord to the AC 120V
connector on the back of the
TV/VCR. Then, plug the other
end into a standard AC outlet.
NOTE:

•

You must disconnect the car battery cord from the
TV/VCR before you use AC power.

•

If some digits appear in the corner of the screen,
press the POWER button without unplugging the
power cord.

2

Turn on the TV/VCR

Press the POWER button to turn on the TV/VCR

3

Select “ENGLISH” or “ESPAÑOL”

Select “ENGLISH” or
“ESPAÑOL”=Spanish using the
F.FWD/

B

or REW/

s

button. “[ ]”

indicate the selected language.

CHANNEL SET UP FOR THE 

FIRST TIME

– SET UP –

B

LANGUAGE
[ENGLISH]   ESPAÑOL

AUTO PRESET

4

Begin auto preset

Press the PLAY/

K

or STOP/

L

but-

ton to point to “AUTO PRESET”.
Then press the F.FWD/

B

button.

The tuner scans and memorizes all
active channels in your area.
NOTES:

•

The TV/VCR distinguishes between standard TV
channels and cable channels.

•

If you want to play or record a video tape
BEFORE presetting the tuner, you must press the
MENU button on the remote control. To preset the
tuner again, see “CHANNEL SET UP AGAIN” on
page 13.

•

The TV/VCR may recognize TV channels to be
CATV channels by the receiving conditions. In this
case, try auto preset again in the fine receiving
conditions.

5

After scanning

The tuner stops on the lowest memorized channel.
If you want to recall the selected channels, you can
select the desired channel directly with the remote
control number buttons or CHANNEL

K

or 

L 

button.

TO SELECT A DESIRED  CHANNEL

You can select the desires channel by using the
CHANNEL

K

or 

L

button or directly pressing the

number buttons on the remote control.
Note for using the number buttons:

•

When selecting cable channels which are higher
than 99, press the +100 button first, then, press the
last two digts. (Example: to select channel 125,
first press the +100 button then press “2” and “5”).

•

You must proceed single-digit channel numbers
with a zero (Example: 02 ...  09).

– SET UP –

LANGUAGE
[ENGLISH]   ESPAÑOL

B

AUTO PRESET

 T5207.QX33  01.3.19 10:18 AM  Page 11