Sylvania D6313CB, Owner'S Manual

- 9 -

EN

0B19

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

VHF/UHF COMBINED ANTENNA

The VHF/UHF Rod Antenna (supplied) is detach-
able. Insert the stem of the antenna into the hole on
the upper-back portion of the TV/VCR.Connect the
VHF/UHF Rod Antenna or VHF/UHF Combination
Antenna to the ANT. terminal of the TV/VCR as
shown in the diagram. For the best reception, fully
extend the VHF/UHF Rod Antenna and make the
necessary adjustments. (Avoid touching the top sec-
tion when adjusting.)
NOTE:
Before plugging the Rod antenna into antenna termi-
nal, check that the pin is not bent. If it is bent,
straighten the pin as illustrated, then plug the pin into
antenna terminal.

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor
antenna.

CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX

Use this connection if your cable system connects
directly to your TV/VCR without a converter box.
By using this connection you can:
1) Use the TV/VCR remote to select channels.
2) Program one or more unscrambled channels for

Automatic Timer Recording.

NOTE: This unit will ONLY record and view the
same channel.

CABLE WITH CONVERTER/
DESCRAMBLER BOX OR SATELLITE
BOX

If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown in the diagram.
By using this connection you can also record scram-
bled channels. However, channel selection must be
made with the converter box or satellite box. This
means that channels cannot be changed using the
TV/VCR Remote Control. Unattended timer record-
ing is limited to one channel at a time.

NOTE:
The connection of an indoor antenna may not always
give acceptable TV reception.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connect-
ed to the grounding system of the building as close to the point of cable entry as practical.

Bent pin

Cable

Plug

(Needs to be straightened)

(Straight pin)

ANT.

IN

OUT

Rod Antenna
(Supplied)

VHF/UHF Antenna
(Not supplied)

VHF/UHF
Combiner
(Not supplied)

Flat twin-lead cable

UHF Antenna
(Not supplied)

VHF Antenna
(Not supplied)

From 
Cable System

75-ohm Coaxial
Cable (Not supplied)

Satellite Box or
Cable Box
(Not supplied)

From Cable System or
Satellite Dish

or

or

or

or

 T5207.QX33  01.3.19 10:18 AM  Page 9