Sylvania SY14Q5144C series, Instruction Manual

-7-

10.  Channel 4

– Displays Full Screen of Camera 4.

11.  VCR 

– Press and hold this button to change the display from the camera inputs to the VCR

Audio/Video playback and recording signal. The amber LED light located over this button will be
ON when the VCR mode selection has been chosen.  Press and hold the button again to return to
Actual.  

Enter

– The Enter button is used in Menu Mode and Zoom Mode.

12.  Quad

– Pressing this button activates Quad Mode displaying all 4 camera images.  To freeze a 

picture in Quad mode, first select the desired camera and an ‘F’ letter will appear, pressing it a
second time will Exit from the ‘Freeze’ mode.  

Auto1

– Pressing this button a second time displays full channels in sequential mode.  

Zoom

– Press and hold this button again to zoom in all 4 cameras and sequential cameras.  

Available in Quad, Quad1 (sequential mode) and PIP mode.

13.  Auto2/Auto 3

– This button displays PIP Mode.  Allows you to view two locations simultaneously,

one being the main channel the other camera being viewed in Picture-in-Picture.  To change
or reverse screens continue pressing this button setting to desired main channel and PIP
channel.  (main channel: CH1-CH2-CH3-CH4-STOP-AUTO1) – (sub channel:  CH1-CH2-CH3
-CH4-STOP-AUTO2)

14.  Menu 

– Press and hold this button for approximately 2 seconds to display the Menu feature. Each

new screen is explained in detail in the next few pages.  Use UP/DOWN/LEFT/RIGHT arrow keys
(channel 1 - 4) to move around and change settings

PIP

– This button displays PIP and Dual PIP Modes.  Press this button to display PIP mode. 

Pressing this a second time will display Dual PIP.  Please see below for screen shots of
PIP/Dual PIP:

Screen shots of PIP/DUAL PIP Modes

15.  Standby Switch

– This button will turn the unit into Standby Mode (the amber LED light will be

ON).  In Standby mode, the VCR Out terminal will still output signal (when VCR Output is set to
Quad).  Pressing it again will turn the power ON (the amber LED light will be OFF).  The master
power switch, which controls the monitor is located at the back of the unit. 

PIP

DUAL PIP