5
ASSEMBLY (continued)
6. Locate plug end of long extension cord hanging
down through section (D) and plug into wall outlet.
NOTE: This tree comes with an ON/OFF
foot pedal switch for convenience.
7. Gently pull all branches down and into place. When adjusting branches be sure that all wires are
free of branch hinges.
8. Shape the branches. Starting with tips closest to the pole, shape one tip to the right, one to the left
and one at the center of the main stem. Repeat pattern for each branch.
Fig. 6
TROUBLE SHOOTING
• If entire tree does not light, make sure extension cord plug is securely inserted into a working
electrical outlet.
• If an entire section of the tree does not light:
a) Check to be sure that all plugs within the tree are securely connected.
b) Check fuse in the extension cord and replace if necessary (a spare 5-Amp fuse is
locate inside extension cord plug).
NOTE: 5-Amp extension cord fuse is different
than 3-Amp fuse used in the mini light sets.
• If you are still experiencing problems with the tree please call 1-800-414-3434 for instructions.
CAUTION! – ALWAYS UNPLUG YOUR TREE FROM ITS POWER SOURCE BEFORE
ATTEMPTING EITHER FUSE OR BULB REPLACEMENT.
EXTENSION CORD FUSE REPLACEMENT:
(1 replaceable 5-Amp 125V fuse is attached to foot pedal extension cord)
This product comes with overload protection (fuse). A blown fuse indicates an overload or short circuit.
If a fuse blows, unplug tree from wall outlet. Replace the fuse per instructions below (follow product
marking for proper fuse rating). If the replacement fuse blows, a short circuit may be present and the
product should be reviewed to determine the cause.
1. Unplug product from its power source.
2. Open access cover on top of plug and locate blown fuse.
3. Remove blown fuse.
4. Locate replacement fuse holder attached to cord near plug.
Open holder and remove replacement fuse.
5. Insert new fuse. Close fuse access cover.
CAUTION:
To reduce risk of fire – replace fuse in extension cord with 5-Amp 125 volt fuse ONLY.
Do not replace attachment plug. Discard product if the attachment plug is damaged.
