21
CHECKING THE TURN SIGNAL LIGHTS AND HORN
Turn the ignition switch key to “ON” position.
Turn on the turn signal light switch, and make sure that the front & rear and left & right signal lights
flashes and also check if the warning buzzer sounds.
Check turn signal light covers if they are dirty, crack, or loosen.
Press horn button to check if it works.
CHECKING THE BRAKE LIGHT
Turn the ignition switch key to “ON” position, hold the hand-braking levers for front and rear wheels.
Check if the brake lights come on.
Check the brake light cover if it is dirty, crack, or loosen.
CHECKING FOR FUEL LEAKAGE
Check fuel tank, fuel cup, fuel hoses, carburetor for leakage.
CHECING THE LUBRICATION OF BODY’S VARIOUS MECHANISMS
Check the body’s pivot points if they have enough lubrication.
(For example, the pivot points on the main stand, the side stand, and the brake lever…etc.)
CHECKING THE AIR CLEANER
《
DISASSEMBLE PRCEDURE
》
Remove mounting screws from air cleaner cover.
1. Remove the air cleaner cover, then remove filter element.
2. Take the element out and clean it. (Refer to maintenance
schedule.)
《
ASSEMBLE PRCEDURE
》
Assemble the air cleaner in reverse order of disassemble.
Element
Screw
CAUTION:
Dust deposit is one of the major causes of reducing
output horsepower and increasing fuel consumption.
Change the air cleaner element more frequently to
prolong the engine’s service life if the motorcycle is
driven on dusty roads very often.
If air cleaner is installed improperly, dust will be
absorbed into cylinders, which may cause a
premature wear and reducing output power and
engine life.
Be careful not to soak the air cleaner when washing
the motorcycle. Otherwise, it will cause engine hard
to start.
CAUTION:
Specified specification bulbs should be used for turn signal lights. Otherwise, the normal
operation of turn signal lights will be affected.
Turn on the turn signal light before turning or switching lane to warn driver of vehicles behind.
Turn off the turn signal light immediately by pressing its button down after using. Otherwise,
the flashing of twin signal lights may confuse the drivers of vehicles behind.
CAUTION:
Use only specified specification bulbs, do not use bulbs with different specifications to avoid
damaging electrical system, burning out bulbs, and discharging the battery.
Do not modify or add other electrical components to prevent over load or short circuit which may
result in a fire and burn down the motorcycle in serious cases.
