SYM 2. MAINTENANCE INFORMATION
2-15
BATTERY
Battery Removal
Remove the 4 screws on the floor panel.
Remove battery cap. (4 screws)
Battery cables removal:
1. At first, remove the negative “-” cable.
2. Then, remove the positive “+” cable.
3. Remove the battery.
If there is some rust on battery posts, clean it
with steel brush.
Install the battery in the reverse procedures
of removal.
Caution
HEADLIGHT ADJUSTMENT
Turn the headlight adjustment bolt. And
adjust the headlight beam height.
Then, tighten the adjustment bolt after the
beam height in proper position.
Caution
NUTS, BOLTS TIGHTENESS
Perform periodical maintenance in accord
with the Periodical Maintenance Schedule.
Check if all bolts and nuts on the frame are
tightened securely.
Check all fixing pins, snap rings, hose (pipe)
clamps, and wire holders for security.
To adjust the headlight beam follows
related regulations.
Improper headlight beam adjustment will
make in coming driver dazzled or
insufficient lighting.
If there is rust on the posts very serious,
spray some hot water on the posts.
Then, clean it with steel brush so that
can remove rust for more easily.
Apply some grease on the posts after
rust removed to prevent from rust again.
Battery cover screws
Headlight adjustment bolt
Summary of Contents for ALA125CC
Page 45: ...SYM 13 BRAKE 13 3 MECHANISM DIAGRAM Rear Drum Brake System 0 8 1 2 kgf m 0 8 1 2 kgf m...
Page 93: ......
Page 176: ...SERVICE MANUAL...
