14. STEERING/FRONT WHEEL/FRONT SHOCK ABSORBER SYM
14-6
Remove the left axle ring and dust seal.
Remove the dust seal on the right side of
speedometer gear.
Remove the bearing with the inner type
bearing remover.
Take out the bearing spacer and then
remove the other bearing.
Tool:
Inner type bearing remover
Disassembly (Drum Brake)
Remove the right dust seal.
Remove the bearing with the inner type
bearing remover.
Take out the bearing spacer and then
remove the other bearing.
Tool:
Inner type bearing remover
Bearing Inspection
Turn the inner race of bearing with fingers.
The bearing should be turn smoothly. Also
check if the outer collar is tightly connected
to the wheel hub.
If the bearing do not turn smoothly, or if they
are too loose in the races, or damaged, then,
remove and replace the bearings with new
ones.
Caution
Installation
Install the bearing according to the reverse
procedure of removal.
Apply some grease into the bearing seat of
the wheel hub.
Install the left bearing onto the seat.
Install the bearing spacer and then install
the right bearing onto the seat.
The bearing must be replaced in pair.
Clearance
Clearance
Dust seal
Wheel side collar
Speedometer gear dust seal
Bearing
Bearing
Bearing spacer
DISC BRAKE
Dust seal
Bearing
Bearing
Bearing spacer
DRUM BRAKE
Summary of Contents for ALA125CC
Page 45: ...SYM 13 BRAKE 13 3 MECHANISM DIAGRAM Rear Drum Brake System 0 8 1 2 kgf m 0 8 1 2 kgf m...
Page 93: ......
Page 176: ...SERVICE MANUAL...
