SYM 16. ELECTRICAL EQUIPMENT
16-7
Voltage Check
With a digital voltage meter or multi-meter to
measure battery voltage.
Voltage:
Fully charged: 13.0 – 13.2V (at 20
℃
)
Undercharged: Below 12.3 V (at 20
℃
)
CHARGING
Connect the Charger positive (+) to the
battery positive (+) terminal.
Connect the Charger negative (-) to the
battery negative (-) terminal.
Standard Max.
Charging
current
0.6A 6.0A
Charging time
5~10H 1H
Warning
CAUTION
After installing the battery, coat the terminals
with clean grease.
Strictly keep flames away from a charging
battery.
The charging “ON”/ “OFF” is controlled by
the charger’s switch. Do not control the
charging by battery jump wires.
Turn the charger’s switch “OFF” at first
before or after charging to prevent from
sparks created on the connectors and
explosion.
To charge a battery must be based on the
battery’s ampere-hour showed on label.
Quick charge a battery should be used
only in an emergency.
Make sure the current and charging time
of above description.
The battery will be damaged by too much
current or too rush charging.
When finishing charge, it is necessary to
measure voltage after 30 minutes.
Summary of Contents for ALA125CC
Page 45: ...SYM 13 BRAKE 13 3 MECHANISM DIAGRAM Rear Drum Brake System 0 8 1 2 kgf m 0 8 1 2 kgf m...
Page 93: ......
Page 176: ...SERVICE MANUAL...
