7. Use of each component
9
USE OF BUTTONS
Light Switches
When the switch is turned to this position as the engine is
being started, headlight, rear light, instrument panel light,
and position light will come on.
When the switch is turned to this position as the
engine is being started, rear light, instrument panel light,
and position light will come on.
When the switch is turned to this position, all lights will
go off.
•
Electrical Starter Button
This is a starting motor button (switch) for engine starting.
With the main switch "
", press this button while holding the front or rear brake lever will start
the engine.
•
Engine Stop Switch
Switch to this position to turn off the engine when a state of emergency.
Switch to this position and the engine can be started.
CAUTION:
•
Release this button immediately after engine has been started, and never press the button again to
avoid damaging the engine.
•
This mechanism is a safety design. The engine can only be started after the front or rear brake lever
has been applied.
•
Do not use light system. Turn headlight and turn signal lights to the “
” position when the engine is
being started.
•
If the side stand is put down, the engine will stop immediately.
•
Retrieve the side stand before starting the engine.
ENGING CONTROL SWITCH
•
This switch is located in the luggage box, under the seat.
•
To set on the ENG. control switch, switch it to
〝
ON
〞
.
•
Switch to
〝
OFF
〞，
before start the engine.
•
Be sure the seat locked properly after set on the switch.
Light Switches
Electrical Starter
Button
High/Low Beam Switch
Turn Signal Switch
Horn Switch
Note:
Position Light Function:
This light can indicate the
motorcycle’s position when the
motorcycle is running in dim,
rainy, or foggy weather.
Engine Stop
Switch
Passing switch
