25
10.Inspection and maintenance before riding
STEERING HANDLE FRONT SHOCK ABSORBERS INSPECTION
Perform this check with engine shut off and ignition switch key removed.
Visual check front shock absorbers for damage.
Operate steering handle up and down, and check front shock absorbers for noises due to bends.
Check the bolts and nuts of front shock absorbers with wrenches for tightness.
Shake steering handle up & down, left & right, and front & rear to check if it is loosen, has too much
resistance and pulls to one side.
Check steering handle if it is being pulled too tight by the brake cables.
Take your scooter to SYM Authorized Dealer or Franchised Dealer for a check or adjustment if any
abnormal conditions are found.
【
Figures on the right are for operation checks only
】
CHECKING AND CHANGING FUSES
Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new one having
the same specified amperage rating (7A). Using a fuse of more than 7 amperes, a brass or iron wire to
replace a blown fuse is strictly prohibited to avoid damaging the electrical system and the circuit.
Remove the battery cover screws, and open the battery cover. Fuses are installed in the fuse box
located by the battery.
Fuses must be firmly secured with wire connectors when replacing.
Use only parts having the specified specification to replace electrical components such as light bulbs.
Using parts not having the specified specifications for replacement may cause the fuse to blow and
over-discharge the battery.
Avoid spraying water directly on or around fuse box when washing the scooter.
Take your scooter to your dealer for an inspection if a fuse is blown by unknown causes.
【
REMOVE
】
【
INSTALLATION
】
Wire
Fuse connectors
Fuse
Press in from above
Summary of Contents for JET 100 series
Page 1: ...OWNER S MANUAL...
