•
Light Switches
When the switch is turned to this position as the engine is being started, headlight, rear light,
instrument panel light, and position light will come on.
When the switch is turned to this position as the engine is being started, rear light, instrument
panel light, and position light will come on.
Note:
Position Light Function:
T
his light can indicate the scooter’s position when the scooter is running in dim, rainy, or foggy weather.
When the switch is turned to this position, all lights will go off.
The main switch in the
〝
ON
〞
position, cuts according to this switch, four directions lantern festivals
dodge extinguish do move, also can simultaneously dodge on the display board direction indicating
lamp extinguishes does moves. If stops the vehicle has when the transportation frequent dangerous
position or the vehicle the breakdown, may use the dangerous police to show the switch.
The main switch in the
〝
ON
〞
position, hazard switch only then may close.
•
Electrical Starter Button
This is a starting motor button (switch) for engine starting.
With the main switch "ON", press this button while holding the front or rear brake lever will start
the engine.
CAUTION:
•
Release this button immediately after engine has been started, and never press the button again to
avoid damaging the engine.
•
This mechanism is a safety design. The engine can only be started after the front or rear brake lever
(pedal) has been applied.
•
Do not use light system. Turn headlight and turn signal lights to the “OFF” position when the engine
is being started.
•
High/Low Beam Switch
This is the high and low beam of headlight switching switch. Press this switch to switch between high
and low beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in city)
•
Seat open Switch
Turn ignition switch “ON” and press this button down. Then, the seat will unlock immediately.
This button will return to original position after releasing.
•
Horn Switch
Press this button down when ignition switch is in the “ON” position, the horn will sound.
CAUTION:
D
o not press this button when you are in the area where there’s no honking.
9
7.Use of Each Component
