9
7.Use of Each Component
When this button is shifted, all four indicators (front and rear-right and left) begin to blink
simultaneously, and direction indicators on the instrument panel also flash at the same time. But when
winker switch is operated in this condition, it will return to signal flash function in order of precedence..
When you are experiencing a sudden vehicle problem in the middle of traffic or the vehicle has broken
down, switch on the lights and slowly pull over, keep the lights flashing till the problem is solved.
Shifting the hazard switch again cancels this feature. The hazard lights only can be switched off when
the main switch is in the
〝
ON
〞
position.
•
Electrical Starter Button
This is a starting motor button (switch) for engine starting.
With the main switch "ON", press this button while holding the front or rear brake lever will start the
engine.
CAUTION:
•
Release this button immediately after engine has been started, and never press the button again to
avoid damaging the engine.
•
This mechanism is a safety design. The engine can only be started after the front or rear brake lever
(pedal) has been applied.
•
Do not use light system. Turn headlight and turn signal lights to the “OFF” position when the engine is
being started.
•
Automatic Lighting Connections
Turn the main switch on “
” , at the same time, the electrical connections of lights will be connected
automatically, including LED daytime running lamps
、
low beam headlights
、
rear position lamp and
rear-registration plate illuminating cannot be switched ON or OFF otherwise than simultaneously.
•
Passing Light Button
When pushing the passing light button
, the high beam indicator light goes on to signal the driver of the
vehicle ahead that you are about to pass. The passing light is shut off as soon as the button is released.
•
High/Low Beam Switch
This is the high and low beam of headlight switching switch. Press this switch to switch between high and
low beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in city)
CAUTION:
•
Automatic Lighting Connections are powered by battery, and therefore be aware of keeping main
switch on “
” will run out of the battery without running the engine.
•
Seat open Button
Turn ignition switch “ON” and press this button down. Then, the seat will unlock immediately.
This button will return to original position after releasing.
•
Horn Switch
Press this button down when ignition switch is in the “ON” position, the horn will sound.
CAUTION:
Do not press this button when you are in the area where there’s no honking.
