13
Push the M button. The hour display stops blinking and the minute display starts blinking. Push the S
button to adjust the tens place in the minute display.
Push the M button. The tens place stops blinking and the units display starts blinking. Push the S button
to adjust the units place in the minute display.
Push M button to finish clock setting.
Battery Voltage Gauge
The battery voltage display shows current battery voltage. It is forced display approximately 10 seconds
when the ignition switch is turned on.
Display range: 9~18 V.
Odometer
This odometer shows the total distance in kilometers the scooter has been ridden. It cannot be reset.
NOTE :
When the battery is disconnected, the clock is reset to 12:00 and starts working again when the battery is
reconnected.
If the clock is idled about 30 seconds while setting, it will exit setting mode automatically and starts
working again.
The clock setting will be finished when the clock is idled about 30 seconds while setting the minute
display.
If the ignition switch is turned off while setting the clock, the clock will exit setting mode when the ignition
switch is turned on again.
The clock works normally by the backup power even the ignition switch is turned off.
NOTE :
The data is maintained in the combination instrument even when the battery is disconnected.
When the figures come to 99999, they will return to 0 and the odometer starts working again.
This odometer only shows in kilometers.
