16
Checking front brake lining
Checking oil quantity in brake oil reservoir
Check the brake from behind the brake caliper.
The brake pad must be replaced with new
lining when the brake pad wear limit reaches
the brake disk.
Park the scooter on a level ground, and check
if fluid level is under the “LOWER” mark.
Recommended Brake Fluid: WELL RUN
BRAKE OIL (DOT 3).
Replenishment of front wheel brake fluid
1.Loosen the screws and remove the master cylinder
cover.
2.Wipe clean foreign materials, dirt around the
reservoir, be careful not to let foreign materials fall
into the reservoir.
3.Remove the diaphragm plate and the diaphragm.
4.Add brake fluid to upper level.
5.Install the diaphragm plate and the diaphragm, and
install the master cylinder cover.
6.Please note the diaphragm direction, and do not let
foreign materials fall into the reservoir. And
tighten the master cylinder cover securely.
CAUTION:
To prevent chemical reaction, please do not use brake fluids other than those recommended.
Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or plastic
components to prevent damage.
Brake disk
Upper
Brake fluid
Diaphragm
Master
cylinder cover
Screw
Brake caliper
Brake pad wear
limit grooves
