13
10. INSPECTION AND MAINTENANCE BEFORE RIDING
10.INSPECTION AND MAINTENANCE BEFORE RIDING
(Please refer to the components location diagram for the following components.)
§
ROUTINE INSPECTION
§
Check Items
Check Key Points
Engine Oil
Is there enough engine oil?
Fuel
Is it enough? Is it Octane 90 or above
Front
Braking condition?
(Brake lever free play: 10~20mm)
Brake
Rear
Braking condition?
(Brake
lever free play: 10~20mm)
Front
Is tire pressure normal?
(Standard: 1.75kg/cm
2
)
Tires
Rear
Is tire pressure normal?
(Standard: 2.0 kg/cm
2
for 1 person, 2. 25 kg/cm
2
for 2 persons)
Steering Handle
Does the handle vibrate abnormally or is difficult to turn?
Speedometer, lights, and
rearview mirror
Is it operated properly?
Do lights come on? Can it be seen clearly from behind?
Tightness of Main Components
Are screws, nuts loosen?
Abnormal Points
Do the previous troubles still exist?
CAUTION:
y
If any problem founded during routine inspection, correct the problem before using the motorcycle
again, have your motorcycle checked and repaired by the
“SANYANG dealer or authorized
service personnel”
if necessary.
§
ENGINE OIL INSPECTION AND CHANGE
§
y
INSPECTION:
1.
Use the main parking stand to support the motorcycle on a
level ground, remove the dipstick after engine stopped for
3~5 minutes. Wipe oil off the dipstick and then insert it into
the guide tube again (Do not rotate it.)
2. Remove the dipstick and check whether oil level is in
between the upper and lower marks.
y
Add oil to upper limit if oil is under the lower limit. (Check
cylinder, crankcase…etc for leakage.)
