BATTERY LOADING AND PRE-FLYING
Step 1: First of all, press
the ON/OFF power switch.
Step 2: Insert the power line into the aircraft and
place it on the level ground.
Step 3: Push the throttle lever to the highest position
and then pull itback to the lowest position,this time
there will be one clear sound sending out from the
transmitter,this shows that the flying aircraft has
entered into the pre-fly state.
CAUTIONS:
1.When the indicator of the transmitter appears eternal bright,however, the indicator of the helicopter
appears slow flashing, this means that decoding is not successful. This time please disconnect the
power of the quadcopter and the power of the transmitter and then repeat the pre-flying steps.
2.If the helicopter is tilting to one side abruptly or spinning while hovering, please switch off the power
of the helicopter and the power of the transmitter and then repeat the pre-flying steps.
3.When the indicator of the helicopter keeps flashing slowly, it means that the helicopter has entered
into the state of low voltage protection.This time you need to charge the quadcopter.
MODE SWITCH AND TRIMMING RESET FUNCTION
Mode switch function:
Keep pressing the button A,then switch on
the power of the transmitter and you can
make mode switch between the Mode 1
and Mode 2.
Resetting function of the aircraft:
Keep pressing the button B, then switch on the power
of the transmitter.Enter into the Trimming & Resetting
Mode (It is highly suggested that the freshman should
reset the trimmer first before starting the first-time flying.)
-3-
A
B
