-7-
Product features
1. Low-voltage protection:
2.Over-Current Protection:
3.Level Calibration Function:
When the four indicator lights at the bottom of drone
start flashing, it means that the drone's battery power is
low. At this time, please control the drone return.
Place the drone on a level surface and at the same
time, push both left and right joysticks to the lower right
corners for 2 to 3 seconds; the indicator lights on the
drone will blink rapidly, and they will return to solid
status after about 2 to 3 seconds. The level calibration is
successful.
4.High/Low Speed Function:
Low speed by default when first powered-on. Possible to
switch the function mode of high/low speed by pressing
the right joystick for a short time. It is switched into high
speed mode when two ”beep” sounds come from the
remote control, pressing the right joystick for a short time
under fast speed mode and then one “beep” sound would
come from the remote control,then it is switched back into
low speed mode.
If the drone automatically flies towards the left/right side
while hovering, press in the left joystick and at the same
time push the right joystick right/left slightly to fine tune the
direction. Don’t release the left joystick until the drone is
flying in a stable state.
If the drone automatically rotates and flies towards the
left/right side while hovering, press in the left joystick and
at the same time move it to the right/left slightly to fine
tune the direction. Don’t release the left joystick until the
drone is flying in a stable state.
Left/right side turning trim control
Left/right side flight trim control
When the drone encounters direct impact from a foreign
object, or is obstructed, or the blades are not rotating, the
drone will go into the over-current protection mode.
