2. Over-Current Protection:
If the drone encounters a direct impact from
a foreign object,or is obstructed, or if the
blades are not rotating, the drone will go into
over-current protection mode.
1. Low-Voltage Protection:
When the two green indicator lights at the
bottom of the drone start flashing, it means
that the drone's battery power is low. Please
fly back the drone immediately at this time.
The drone will automatically slow down when
it is short of power.
Front indicator light
(signal light) red
Rear indicator light
(flight control light) green
Left/right side flight trim control
Left/right side turning trim control
Product Features
If the drone automatically flies towards the left/
right side while hovering, press in the left joystick
and at the same time push the right joystick right/
left slightly to fine tune the direction. Don’t release
the left joystick until the drone is flying in a stable
state.
If the drone automatically rotates and flies towards
the left/right side while hovering, press in the left
joystick and at the same time move it to the right/left
slightly to fine tune the direction. Don’t release the
left joystick until the drone is flying in a stable state.
3. Level Calibration Function:
Place the drone on a level surface and at
the same time, push both left and right
joysticks to the lower right corners for 2 to
3 seconds; the LED light indicator on the
drone will blink rapidly, and it will return
back to the normal status after about 2
to 3 seconds. The level calibration is
successful.
-8-