2016 Symantec Corporation This document may be freely reproduced & distributed whole & intact including this copyright
notice.
17
Figure 2
–7.2
SV3800B/SV3800B-20 Back Panel
Three covers on the upper surface of the SV3800/SV3800B/SV3800B-20 can be
removed to gain access to the interior of the unit. These covers should not be
removed by end users, and may require removal by trained field engineers when
maintaining a system.
The three covers can be seen fitted in Figure 2-8, and are shown removed in
Figure 2-9. These panels need to be sealed with tamper evident labels when
operating in FIPS 140-2 mode.
Section
"3.2 Tamper Evident Label Management and Application Instructions"
provides guidance on how and where tamper evident labels need to be applied to
the SV3800/SV3800B/SV3800B-20.
Figure 2
–8 SV3800/SV3800B/SV3800B-20 Front/Top, covered, with Netmods Installed
Figure 2
–9 SV3800/SV3800B/SV3800B-20 Front/Top, covered, without Netmods Installed
For FIPS 140-2 Level 2 validation the SV3800 was tested with the following
configuration:
•
SV3800 chassis with 2 x NFE acceleration card installed
•
2 x Intel 5645 hex core CPUs and 48GB of memory
This configuration is model number SV3800.
For FIPS 140-2 Level 2 validation the SV3800B was tested with the following
configuration:
•
SV3800B chassis with 2 x NFE acceleration card installed
•
1 x Intel E5-2640 V3, 8 core CPU and 64GB of memory
This configuration is model number SV3800B.
