2016 Symantec Corporation This document may be freely reproduced & distributed whole & intact including this copyright
notice.
46
SV3800, SV3800B, and SV3800B-20 Security Policy
3.2.2 Supplied Labels
If tamper evident labels require fitting or replacing then this must only be done by
the Crypto Officer using a label kit obtained from Symantec Corporation.
Labels are supplied in a kit that includes four labels in a bag and one label on the
bag. The two smaller labels are 1.5 x 0.6 inches, and are identical. The two larger
labels are 2.875 x 1.0 inches, and are identical. The serial number on all labels and
on the bag must all be the same.
Figure 3
–12 FIPS Label Kit
Labels that are applied to the box have the number printed on them twice, once
for each plane the label will be in. Each label goes around an edge and secures two
planes.
The supplied label kit should be inspected as follows:
•
If the labels do not have matching number, or if the bag has been opened,
reject the labels.
•
If the style of letters does not appear to be the same on all labels, reject the
labels. The size of the lettering is smaller on the smaller label.
•
If the labels indicate tampering, reject the labels.
The two larger labels in the bag are identical. These are applied to the edge
between the top of the chassis and the sides. These labels are white with blue ink.
The two smaller labels in the bag are identical. One of these labels is applied to the
top, rear cover of the chassis. The remaining label is applied to the top cover of
the chassis. These labels are also white with blue ink.
The entire label packet must be rejected if the large or small labels are not
identical, or if the colors are not white with blue ink.
