2016 Symantec Corporation This document may be freely reproduced & distributed whole & intact including this copyright
notice.
47
It is not possible to purchase individual replacement labels. They are only
provided as a kit. All four of the labels in the kit should be applied to the system.
shows a FIPS label kit; the label numbers have been obscured for
security.
3.2.3 Label Application
The labels must be applied to the unit without the slide rail kit attached. This can
be done before installation or by removing the unit from the rack.
Note: Warning. Removal of the unit may require two people and should
only be done by qualified personnel.
Note: Warning! Failure to follow correct procedure can cause the unit to fall
and may cause damage to the unit, other equipment or injury to personnel.
If the unit is mounted in a rack, the unit must be removed. If the unit uses the
standard slide kit, follow these steps:
1.
Power off the unit.
2.
Disconnect all cabling.
3.
Provide a clean work surface for applying the labels.
4.
Remove the two screws that (optionally) hold the front of the unit to the rack
rails. These may not be installed.
5.
Pull the unit out from the rack until it stops.
6.
Slide the black arrows on the inner slide pieces forward.
7.
While holding the arrows, carefully slide the chassis out of the out slide
pieces.
8.
Remove each inner slide piece by pressing the square button and sliding the
inner slide piece toward the back of the unit. This will disengage it from all
supports.
To reinstall the unit, follow the installation guide procedure.
Left Side Label Application
The left side label (one of the larger labels which is white, with blue ink) is applied
between the middle and rear top covers, this is denoted label 1. It indicates
tampering if either of these pieces is removed. Installation involves the following
steps:
1.
Peel the label from its backing.
2.
Place the alignment line along the top left edge of the chassis such that the
label is centered on the seam. The markings should be oriented so that the text
is “up.”
