2016 Symantec Corporation This document may be freely reproduced & distributed whole & intact including this copyright
notice.
49
4.
Starting at the edge, press on the label and work down toward the bottom.
Make sure that there are no bubbles. Make sure the screw is fully covered.
Verify that the label does not hang over the edge of the tab.
5.
Starting at the edge, press on the label and work toward the center of the
chassis. Make sure that there are no bubbles.
6.
Press firmly to all parts of the label to make sure it is fully applied.
7.
Confirm that the screw on the rear tab is fully covered.
Top Label Application
The top label (one of the smaller labels which is white with blue ink) is applied to
the center between the front and middle top covers, this is denoted label 4.
This label has a shorter section and a longer section. The shorter section goes on
the front top cover and the longer section goes on the middle top cover.
Installation involves the following steps:
1.
Orient the label so that the text is “up.”
2.
Remove the label from the backing.
3.
Place the alignment line along the top center between the front and middle
top covers of the chassis. The shorter section goes on the front top cover and
the longer section goes on the middle top cover.
4.
Starting at the edge, press on the label and work down toward the bottom.
Make sure that there are no bubbles.
5.
Press firmly to all parts of the label to make sure it is fully applied.
Follow the installation guide to reinstall the chassis into the rack.
3.2.4 Label Inspection
The Crypto Officer must verify that all tamper evident labels are in place and
undamaged. The following should be checked at regular intervals:
•
Matching numbers.
•
Correct colors of label and ink.
•
Correct numbers if this information is recorded.
•
Indications of tampering (“VOID” markings on the labels).
•
Missing labels.
•
Labels that do not stick properly.
•
Labels that have the edges damaged.
•
Discolored or distorted labels.
Following the above guidelines, tamper evident labels at four locations on the
SV3800/SV3800B/SV3800B-20 should be checked in order to ensure that the
unit cannot be opened in a manner that allows access to components within the
cryptographic boundary.
Figure 3-13.1 shows the location of the tamper evident label that should be fitted
to the rear of the SV3800. The label is applied over the top of the screw that secures
