Charging the battery pack
!
If you are using a 9-volt alkaline
battery in your PTC-960L, replace the
old battery with a new battery
whenever you receive a low-battery
warning. You cannot charge alkaline
batteries.
Charge the PTC-960L’s nickel-cadmium battery pack
when you first receive the unit and whenever the
pack becomes weak. The Low Battery icon appears on
the ninth line of the display when the battery is
running out of power.
The pack can also be charged via a
communication cradle or a fast bat-
tery charger. Contact your Telxon
representative for information.
Use the following procedure to charge the PTC’s
nickel-cadmium battery pack via a battery charger.
Equipment required:
•
A battery charger
To charge the battery pack outside
of the U.S. or Canada, you need a
charger designed for a 220-volt AC
outlet.
•
An electrical outlet within 6 feet (1.8 meters)
providing 110 volts AC in the U.S. or Canada
1.
Make sure the PTC is off.
2.
Disconnect any accessories from the PTC.
3.
Connect the battery charger’s cable to the PTC’s
micro DB-15 connector.
4.
Plug the battery charger into the electrical outlet.
The PTC’s Charging LED glows.
5.
Charge the battery pack for 12 hours.
6.
When charging is finished, disconnect the charger
from the PTC and the outlet.
Turning on the PTC-960L
1.
Press the ON/OFF key to turn on the PTC-960L.
14
