17/26
User’s Guide
6200 Digital
Voice Processor
To download the latest version of 6200 Designer, a Windows GUI
application interface for the 6200, go to: www.airtoolsaudio.com
TM
Symetrix
Engineered by
6200 Designer Installation
The 6200 Designer software provides real-time control and a simple drag ‘n drop, point ‘n click configuration interface to the
6200 from a Windows 98/2000/XP PC environment.
Use one of the following procedures to install the 6200 Designer on your computer.
From the 6200 Designer CD-ROM:
1. The software should auto run after inserting the CD-ROM into your computer’s CD-ROM drive.
2. If the software does not auto run, then Click on the Start button, choose Run and type “D:\SETUP”
(If your CD-ROM drive isn’t D:, then substitute its drive letter)
From the AirTools web site (http://www.airtoolsaudio.com):
1. Download the 6200 Designer program file.
2. From the Start button, Run the file/program that you just downloaded to start the Setup program.
The software always starts up in offline mode. Regardless, you can explore the software, experiment to your heart’s content,
and perhaps even get useful work done. You can save any Sites (complete with up to 256 programs) that you create to a file
that can be downloaded later into an operating 6200.
If there is a 6200 hardware unit connected, you can go download to, and upload from the 6200. Once you have a unit
connected, you can also work online in real time, which allows you to hear adjustments and settings as you make them. Follow
the steps in the following sections to get your hardware connected to your PC.
USB Connection and Driver Installation
When you install the 6200 Designer software, a USB driver for the 6200 is also installed into the 6200 Designer program
directory. If you wish to control the 6200 using USB, follow the instructions below to install the USB driver.
1. Install the 6200 Designer software (using one of the methods outlined previously).
2. Plug your computer into 6200 using an appropriate USB cable. The 6200’s front panel USB port is a Female “B” type USB
1.1 port.
3. Your computer should automatically detect that a new USB device is present.
4. The Windows “New Hardware Wizard” should pop up.
5. When asked “Can Windows connect to Windows Update to search for software?” choose the “No, not at this time” option
and click the Next button.
6200 Designer Installation, USB Connection and Driver Installation
Summary of Contents for airTools 6200
Page 32: ......
