9
Jupiter
6408 216th Street SW
|
Mountlake Terrace, WA 98043 USA
T
+1.425.778.7728
F
+1.425.778.7727
|
www.symetrix.co
Power
POWER INPUT
Connect the locking power plug connector end of the supplied AC cord
to the receptacle on the rear of Jupiter. Connect the AC connector end of
the supplied AC cord to an AC power source that is of the correct voltage
and frequency (100-240 VAC, 50-60 Hz). Use only the power cord and
connector specified for the product and your operating locale.
When Jupiter is powered up correctly, the POWER LED on the front of the
device will be lit solid green.
Audio
ANALOG
MIC/LINE INPUTS
Using standard mic/line cables terminated on one end with
terminal block connectors and appropriate connectors for your
mic/line sources on the other end, connect the terminal block
ends into the ANALOG MIC/LINE INPUTS of Jupiter and the
opposite ends into your source devices’ outputs. Refer to the
Audio Wiring Reference
for more information.
NOTE:
Wiring the inputs to an unbalanced cable will typically
result in an input level that is 6 dB lower than the input level
achieved using a balanced cable. If wiring to an unbalanced
source, you may need to adjust Jupiter’s input level. Refer to the
INPUT LEVEL within the INPUTS panel in the software.
ANALOG
LINE OUTPUTS
Using standard mic/line cables terminated on one end with
terminal block connectors and appropriate connectors for your
destination devices on the other end, connect the terminal
block ends into the ANALOG LINE OUTPUTS of Jupiter and
the opposite ends into your destination devices’ inputs. These
outputs are +4 dBu balanced line level outputs by default. If
you need an unbalanced output, see the analog audio wiring
diagrams in the
Audio Wiring Reference
.
NOTE:
Wiring the outputs to an unbalanced cable will typically
result in an output level that is 6 dB lower than the output level
achieved using a balanced cable. If wiring to an unbalanced destination,
you may need to change Jupiter’s output level. Refer to the OUTPUT
LEVEL within the OUTPUTS panel in the software.
Control
ETHERNET
Using a standard straight-through CAT5 cable terminated with RJ45
connectors, connect Jupiter’s ETHERNET port to either your computer’s
Ethernet port or to an existing Ethernet network. You may wish to review
the Network Configuration section for more information. When Jupiter has
a physical network connection, the amber “link” LED on the ETHERNET
connector will be lit solid. When there is network communication, the green
“activity” LED on the ETHERNET connector and the NETWORK LED on the
front of the device will flash accordingly.
NOTE:
Jupiter’s Ethernet port will automatically sense a device-to-device
connection so that a standard straight-through Ethernet cable may always
be used. A cross-over cable is not required.
NOTE 2:
The Ethernet connection is also available for 3rd party control.
Refer to the control protocol document available on the Symetrix web site
or within the Jupiter software help file for more information.
Hardware Connections
Summary of Contents for Jupiter 12
Page 1: ...Jupiter 4 Jupiter 8 Jupiter 12 Quick Start Guide ...
Page 2: ......