Symfony WebPal
®
10
User Manual
Page 6
Configuring The WebPAL
®
1. Click
“Start”
on the Windows CE Taskbar, select
“Setting
s
”
, and then click on
“Control panel”
.
2. The Control Panel displays several icons associated with utilities for configuring the WebPAL 10.
Many of these are self-explanatory. The most common utilities are discussed below.
a) Display Quality set up
i. Click on
“Display”
. The Display Properties window will appear.
ii. You can use
“Brightness”
to adjust the brightness of the displayed images. Tap on the left
arrow to darken the display darker or on the right arrow to increase the brightness.
b) Network Configuration
i. Double-click on the
“Network”
icon.
ii. Click on
“Network”
, the Network Configuration will appear.
iii. Click on
“Adapters”
, a list of the network drivers installed on your device will be displayed.
Select the adapter that you currently use, then click on
“Properties”
.
iv. You have two options:
“Obtain an IP address via DHCP”
or
“Specify an IP address”
.
v. When you select
“Obtain an IP address via DHCP”
, you are expecting that an IP address can
be automatically assigned to this device. Then click on
“OK”
at the top of the window for
confirmation.
vi. When you select
“Specify an IP address”
; you ask your network administrator for an address
and type it in the space provided (IP Address, Subnet Mask, and Default Gateway). In
addition, you have to specify additional
“WINS”
or
“DNS”
in
“Name Servers”
, then click on
“OK”
at the top of the window for confirmation.
vii. You may need to set up a user name, password and Domain. Click
“Identification”
in
Network Configuration window, input your
“Name”, “Password”
and
“Domain”.
Windows
CE uses the information to identify your right to access the network. Then click
“OK”
at the
top of the window for confirmation.
c) Stylus Setup and Calibration
i. Double-click
“Stylus”;
the Stylus Properties window will appear.
ii. You can test the
“Double-Tap”
function; follow the instructions to double click the two
squares right of the Window. If correct, click on
“OK
” at the top of the window for
confirmation.
iii. If you want to recalibrate or your device is not responding properly to your taps, select
“Calibration”,
follow the instruction to recalibrate. When you are done, click on
“OK”
to
continue.
Configuring the WebPAL
®
