DOC06501_Revision
F
ATS-6501 Users Guide
16
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4394A
2.4.2.2 4395A-10 (10MHz) / 4395A-5 (5MHz)
No programming is required for these modules. These modules will also work in any of
the 6 output card slots.
2.4.2.3 4387A (Modulated IRIG/NASA36)
This module provides four Amplitude Modulated (AM) IRIG Outputs or the NASA36
Serial Time Code. Valid AM IRIG Codes are A(130, 133, 137), B(120, 123, 127), E(111, 112,
121), G(141, 142, 147), and H(111, 112, 121, 122, 127). Default is B120.
IRIG:
To set the IRIG Code for the individual ports use the
irig
command:
ATS-6501> irig [slot#] [port#] [Code A-H] [Code Format <NNN>]
The following example sets the IRIG Code for Slot 5, Port 3 to G 141.
ATS-6501>irig 5 3 G 141
The system will generate an error message if the operator attempts to enter an
unsupported or invalid code.
To verify the settings use the
settings hardware:outputs:slots:N
command (where N=Slot
#) to obtain the current settings for a particular card.
ATS-6501> settings hardware:outputs:slots:5
[tsc4387]
[ports]
[1]
[format] B
[signal_word] 120
[type] irig
[2]
[format] B
[signal_word] 120
[type] irig
[3]
[format] G
[signal_word] 141
[type] irig
[4]
[format] B
[signal_word] 120
[type] irig