DOC06501_Revision
F
ATS-6501 Users Guide
56
Users can determine which output module(s) has failed:
Based on which systems the ATS-6501 is driving are no longer operating properly
By unplugging the output modules, one at a time, to see which output module was at
fault.
Note
: If this does not work there may be more than one output module that failed. Pull
them all and reinsert them one at time to see which one(s) cause a FAULT.
By using the
status health:output_modules
command and/or the
syslog error
command
and checking both the active = true and/or occurrences is greater than 0.
ATS-6501>status health:output_modules
[1]
[active] true
[occurrences] 1
[2]
[active] false
[occurrences] 0
[3]
[active] false
[occurrences] 0
[4]
[active] false
[occurrences] 0
[5]
[active] false
[occurrences] 0
[6]
[active] false
[occurrences] 0
6.2.3 GPS Performance
There are several factors that could impact the performance of the GPS receiver.
6.2.3.1 Poor GPS Receiver Performance
There are several issues that can cause poor performance with the GPS receiver. This
may be reflected in the signal quality parameter or the fact the ATS 6501 GPS Tracking indicator
goes out periodically. Use the
status gps
command to look at the current system status.
ATS-6501>status gps
[mode]
[desc] tracking
[value] 4
[model]
[hw_version] OEMV3G-4.00-X2T
[name] L12LV
[serial_number] DAB08400198
[sw_version] 3.400
[position]
[alt] 5.05031000001
[fixed] true
[lat] 3.84662816101
[lon] -7.74408654901
[satellite]