S100 User Guide – Rev. D – June 2005
45
2
5
3
There is no output to the “Mail test” field. That is because mail is tested by sending an e-mail
to the address that you indicated earlier.
Click
Finish
.
Setup Complete dialog
This screen verifies your configuration of the S100:
•
Its time source
•
Host name
•
System location
•
Administrator e-mail
Configuring NTP
To configure NTP, use the NTP Relationships dialog (See
“NTP Relationships” on
page 58)
. Use the dialog to view the NTP status and create the NTP associations.
IRIG-B (v.120,122,123)
Both the D-BNC Signal Breakout Cable and the optional Rubidium oscillator cable provide a
Timecode Input connector. To use IRIG time code as a reference, connect the IRIG signal to
the Timecode Input connector, select
IRIG-B
(see
Figure 3-16
), and click
Next
.
If you wish to use dial-up as a backup time source to GPS, click the checkbox next to
Use
dialup for backup to IRIG-B
, then the
Next
button.
If you do not want to back up your IRIG with dial-up, leave the checkbox unselected, and click
Next
.
Figure 3-33:
Your set-up is complete
Summary of Contents for SyncServer S100
