88
TimeProvider 500 2.0 User’s Guide
098-00172-000 Revision A – December, 2009
Chapter 4 CLI Commands
Set Commands
set configuration
This command resets user-defined settings to known values with a single
command. The factory configuration will change all settings. The default
configuration is a subset of the factory configuration and
will not
change
communication-related settings such as TimeProvider 500’s IP address. The default
configuration is less extensive and potentially more useful in some situations. See
for more information.
Syntax:
set configuration { default | factory }]
Default:
TimeProvider 500 ships with its configuration set to factory.
Example:
Sets TimeProvider 500’s configuration to the factory settings.
set configuration factory
Response:
Setting configuration to factory
set eia-232 baud
This command is updated from version 1.0 to support changing baud rate
.
This command sets the baud rate on the RS232 MGMT connector.
Syntax:
set eia-232 baud { 4800 | 9600 | 19200 | 38400 | 57600 }
Default:
Baud = 57600
set firewall
This command creates a firewall to block remote use of the selected capability.
Syntax:
set firewall { telnet | icmp } { allow | block }
Default
:
Note
: The
set configuration factory
command will reset this
setting. The
set configuration default
command will not
change the current setting.
Summary of Contents for TimeProvider 500
Page 10: ...Table of Contents 10 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...
Page 12: ...List of Figures 12 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...
Page 146: ...146 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 T1 Format ...
Page 174: ...Index W W 174 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...