098-00172-000 Revision A – December, 2009
TimeProvider 500 2.0 User’s Guide
91
Chapter 4 CLI Commands
Set Commands
set ip
This command is updated from version 1.0 to support connection interfaces
.
For more information about connection interfaces, see
set
ip
command sets the IP address, gateway, and network mask for
the TimeProvider 500 interface connection. Once an IP address is changed, the
settings take effect immediately. You can only set an interface connection when the
interface is enabled. See
Syntax:
set ip [if0|if1|if2|if3|if4] <ip address> netmask <netmask> gateway
<gateway>
Range:
Range for all settings = [0, 1, … , 255]
Default:
set configuration factory
configures the TimeProvider 500 to the
following settings:
for individual interface connections:
if0 address = 192.168.1.9
if1 address = 10.1.1.1
if2 address = 10.1.2.1
if3 address = 10.1.3.1
if4 address = 10.1.4.1
for all interface connections [ if0 | if1 | if2 | if3 | if4 ]:
Netmask = 255.255.255.0
Gateway = 0.0.0.0
Example:
Sets the IP address to; 192.168.2.52; netmask 255.255.255.0 gateway;
192.168.2.1.
set ip if1 192.168.2.52 netmask 255.255.255.0 gateway 192.168.2.1
Response:
Note
:
Attempting to set an existing connection interface IP
address to any of the other four interface connections will
cause the command to fail.
All interfaces should be configured for
separate subnets.
Summary of Contents for TimeProvider 500
Page 10: ...Table of Contents 10 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...
Page 12: ...List of Figures 12 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...
Page 146: ...146 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 T1 Format ...
Page 174: ...Index W W 174 TimeProvider 500 2 0 User s Guide 098 00172 000 Revision A December 2009 ...