098-00028-000 Revision F – May, 2012
TimeProvider 5000 User’s Guide
35
Chapter 1 Overview
TimeProvider 5000 Connections
Communications Connections
The IMC allows user control of the TimeProvider 5000 through either the Ethernet
Management port or the EIA-232 serial port.
Ethernet Management Port
The Ethernet Management port on the IMC is standard 10/100Base-T shielded
RJ-45 receptacle. To connect the TimeProvider 5000 to an Ethernet network, use a
standard twisted-pair Ethernet RJ-45 cable (CAT5 minimum).
Expansion Management Port
The expansion Management port on the IMC is a standard 10/100Base-T shielded
RJ-45 receptacle. To connect the TimeProvider 5000 to a TP E10 or TPE30
expansion shelf, use a standard twisted-pair Ethernet RJ-45 cable (CAT5
minimum).
The connector pinouts for the expansion Management port, and all expansion ports,
are listed in
Table 1-4. Expansion RJ-45 Connector Pin Assignments
Pin
Signal
Comment
1
RX+
(Receive positive)
Ethernet (10/100Base-T)
2
RX
(Receive negative)
Ethernet (10/100Base-T)
3
TX+
(Transmit positive)
Ethernet (10/100Base-T)
4
Reserved
5
Reserved
6
TX
(Transmit negative)
Ethernet (10/100Base-T)
7
DTI+
DTI
8
DTI
DTI
Summary of Contents for TimeProvider 5000
