Installation Instructions
APEX-SYMAC Series
11
Rotational Adjustment
NOTE:
(Optional) Rotational adjustment may be locked by
installing rotational locking screw (E) into back of
faceplate. (See Figure 15)
Figure 15
5.
The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
14)
6.
Use 3/16” hex key (K) to adjust rotational adjustment screw
to adjust rotational tension. (See Figure 14)
Lift Arm Tension Adjustment
1.
Use 3/16” hex key (K) to adjust lift arm tension adjustment
screw. (See Figure 16)
Figure 16
NOTE:
Tension may also be adjusted with upper tension
adjustment screw inside cable management cover and
1/8” hex key (L). (See Figure 17)
Figure 17
Adjustments - APEX-SYMAC2D only
Display Adjustments
1.
Loosen knobs securing faceplates to array. (See Figure 18)
2.
Slide displays laterally on array to adjust lateral shift. (See
Figure 18)
3.
Adjust pitch and pivot position as desired. (See Figure 18)
4.
Tighten knobs to secure faceplates in position. (See Figure
18)
Figure 18
(E)
(APEX-SYMAC1 shown)
1
Reduce tension
Increase tension
(lighter display)
(heavier display)
DO NOT
over-tension adjustment
tension screw.
underside view
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
2
3
2
1
4
3
3
3
