10
L.
Connect the Wires as per the diagram below. Use the adhesive-backed Cable Clips (Part #18) to
secure the Connecting Wires, so they don’t sag.
M.
Turn the assembled desk right-side-up. With two people, grab the desk by the base (not the desk-
top) and turn the desk right-side up. Adjust the Leveling Studs on the Feet (Part #2) as needed.
N.
Plug the Power Cord into a
110v electric
outlet.
*** IMPORTANT! ***
YOU MUST RESET THE DESK PRIOR TO USE:
For the first time use it, press and hold the “DOWN”
button on the Keypad until the desk reaches its
lowest height and bounce back and shows the
lowest position height, then release the Keypad,
reset done.
Your desk is now ready to use.
To program up to four presets:
Use the up/down buttons to find a desired height, then press “M” followed by a number 1 – 4.
To switch display height from cm to inch, or inch to cm :
Press hold “M” and “UP” buttons for 15 seconds, the height display will switch to another metric.
