7
F.
Use a tape to measure the width, and adjust the cross rail in the middle of the frame. set up
the width you want, Fit the control box into the desk frame. Then tighten the screws
G.
Your desktop may or may not be pre-drilled. Please check both sides of the desktop before
placing the desk base on it for pre-drilling! Carefully place the upside down desk base on the
underside of the desktop.
Note: minimum top size: 47.2” wide x 23” deep
Adjust the width of the base to fit the desktop by
sliding the two halves outward
(
43.3”
to
78. 7 ”
max).
Place the base where you want it. Some will want the frame to be
all the way to the edge of the desk. We recommend leaving at least
1/2” of desktop width (on each side) , protruding beyond the frame
width.
Depth: The minimum depth top you can use is 23”. We recommend that you center the base on the
desktop (front to back). If your top is 25.5”-27.5” and you want the rear edge of the top in line with
the rear edges of the feet, offset the top toward the back.
Center the frame by using the desktop edge
as a reference. Measure to the metal brace.
Do not use the screw holes as a point of reference.
