Rinnai Australia
10
Operation & Installation Manual
REMOTE / THERMOSTAT CONTROL
REMOTE CONTROLLER - BATTERY INSTALLATION
Carefully remove the battery compartment cover panel from the rear of your controller hand-set
and insert the two AA batteries supplied ensuring that '+' and '-' polarity is correct. After installing
the batteries your remote control will display an 'Initial Set-up Screen' with the current room
temperature in °C, a default time setting of
and the default day of the week set to
‘MO’
- Monday.
REMOTE CONTROLLER - SYNCHRONISATION.
REMOTE CONTROLLER - MANUAL OPERATION
Turning ‘ON’
Step 1). Press ‘ON’/‘OFF’ button of the Push Button Control Panel
once the Power Indicator LED
, will
illuminate blue.
Step 2).Press both the
‘OK’
and
‘PWR’
buttons on the controller at the same time. Operational control is now
transferred to the controller, the heater operation is then dependant on the controller mode as follows:
In Manual Mode
- Unless the set temperature is above that of the room temperature the heater will not
ignite and the power Indicator LED
will illuminate to indicate that the heater is in Controller Standby
mode. Raising the set temperature above that of the room temperature will start heater operation and the
Power Indicator LED
, will change from red to blue.
Turning ‘OFF’
Step 1). To place heater into controller standby press the
‘PWR’
button once. The heater will go into ‘Standby’
mode and the power Indicator LED
will illuminate.
Step 2).To turn the heater 'OFF' press the 'ON'/'OFF' Button
twice. The Power Indicator LED
, will be
extinguished to indicate that the appliance has returned to the OFF condition.
Changing the temperature
The Symmetry has temperature increments of 1° which can be changed using the
‘UP’
and
‘DOWN’
buttons.
The temperature control range is 7 - 32°C
When batteries are changed all settings other than synchronisation are lost and
the controller will revert back to the 'Initial set -up screen'.
Before proceeding with synchronisation ensure that the gas and electricity are connected.
Synchronisation must be carried out when a new controller has been purchased. Two controllers
CAN NOT be used at the same time! The heater will not respond the controller until
synchronisation has been carried out.
Synchronisation of Controller and The Heater
Step
1). Turn the power off at the power point for a minimum of 30 seconds,
synchronisation will not be possible unless the minimum 30 seconds has been
observed.
Step 2).Ensure the remote control is turned OFF, to turn OFF press and release the ‘PWR’
button once.
Step 3).Turn the power ON at the power point, the blue power operation indicator on the
push button control panel will flash once. The controller can now be synchronised
with the heater.
Synchronisation MUST BE performed within 30 seconds of the power being turned ON, if more
than 30 seconds has elapsed repeat steps 1 through 3.
Step 4).On the controller in quick succession press the following sequence of buttons:
‘P’ > ‘T’ > ‘T’ > ‘UP’
The LCD display will show ‘L/C’ (Learn Code) for 2 seconds then return to the normal ‘OFF’ state display.
The blue power operation indicator
on the push button control panel will flash once to indicate that
synchronisation has been accepted.
To restore factory default settings
With the thermostat ‘OFF’, press the following sequence of buttons
‘P’ > ‘T’ > ‘T’ > ‘DOWN’.
NOTE
NOTE
b
a
Square
Fascia
Bevelled
Fascia
b
a
NOTE
b
a
b
b
b
b
a
b
