Rinnai Australia
15
Operation & Installation Manual
REMOTE / THERMOSTATIC CONTROLLED OPERATION
Automatic Timer Mode
•
In automatic timer mode temperature is regulated to the programmed level and time.
•
Time and day of week
MUST BE
set
.
Step 1.
With the controller turned ‘ON’, press and release the ‘
A/M’
button
until the word ‘
AUTO’
appears
on the LCD.
Step 2.
At any time press the
‘UP
’ button
or
‘DOWN’
button
to increase or decrease the temperature in
increments of 1°C.
Flame Mode
•
Temperature control is over ridden and the flame size can be set to any setting from F7 highest to F1 lowest.
•
Time and day of week does not need to be programmed.
Step 1.
With the controller turned ‘ON’, press and release the ‘
A/M’
button
until the letter
‘F’
with a number
and the flame symbol
appear on the LCD panel.
Step 2.
Press the
‘UP
’ button
or
‘DOWN’
button
to increase or decrease the flame height.
Manually Overriding The Set Program
At any time, the temperature or fan speed may be adjusted ‘UP’ or ‘DOWN’ similarly to operating in “Manual
Temperature Mode” on page 14.
When the fire first ignites it remains on highest flame for the first 60 seconds before changing to
the selected flame height.
The fan speed automatically adjusts to the corresponding flame height. It is not able to be selected
by the operator. See the flame table below for flame height to fan speed relationship.
Flame Height
1
2
3
4
5
6
7
Fan Speed
HIGH
LOW
LOW
LOW
HIGH
HIGH
HIGH
However, whenever the thermostat changes to a new time period, the temperature will be set
automatically according to that period’s setting.
A/M
PWR
T
P
DOWN
UP
OK
A/M
PWR
OK
T
P
A/M
PWR
T
P
DOWN
UP
OK
PWR
OK
T
P
DOWN
UP
STEP 1
13
STEP 2
15
10
13
10
15
NOTE
A/M
PWR
T
P
DOWN
UP
OK
PWR
OK
T
P
DOWN
UP
STEP 1
STEP 2
13
A/M
PWR
T
P
DOWN
UP
OK
A/M
PWR
OK
T
P
10
17
17
15
13
17
10
15
NOTE
NOTE
