1. Install all U pipes into the outer pipes locate the base per pilot hole
pattern or in desired location.
2. Secure U pipes by tightening set screws with provided 5mm Allen key.
3. Fully install the four M6x16mm screws to secure table configuration.
Note:
When combining two surfaces, place the tops in
position and then place the entire base assembly
in position on top of the face down tops. Locate
and install each mending plate as shown using
the 8 M5x19mm screws provided. Location of the
plates may vary based on table size and presence
of grommets.
3
1
90°
or
1
2
120°
1
For more information, visit www.symmetryoffice.com
To report any issues with this product, please contact our customer service department at (888) 552-5699
4
SWITCHBACK 3-LEG-C-STYLE ASSEMBLY INSTRUCTIONS
2
