Voyager | 10
ASSEMBLE THE COLUMN TO THE BEAM
Make sure that the male hex adapter on the column is aligned
with the female hex adapter in the motor. If they are not aligned,
use a 9mm wrench to turn the male hex adapter on the column
to align with the female hex adapter in the motor.
Warning: Failure
to do so will damage the motor!
Do not try to turn the female hex
adapter in the motor.
ASSEMBLE THE TOP SUPPORT TO THE BEAM
AND COLUMN
Assemble using the M8x1.25 x 12mm length screws (4 per
column). The maximum tightening torque for these screws is
24Nm (18 lbs-ft). Align top support holes with independent
beam assembly. Repeat as necessary for remaining columns.
FEED THE MOTOR CABLES THROUGH
THE HAT CHANNEL CUT OUT*
*
For tables with a HAT channel
ASSEMBLY INSTRUCTIONS
Column
Male Hex
Motor
Female Hex
2
3
4
