User’s Manual
Synaccess Networks, Inc.
www.synaccess-net.com
(760) 930 – 0473 Page 34 of 46
activities are displayed.
“/emailvbs 2” sets to the system to level 2 verbose mode, in which detailed emailing
activities are displayed.
•
Use command “/emailget” to check incoming emails immediately.
•
Use command “emailsend” to send a test mail immediately
4.4.2 Sending Data to User Serial Console Ports:
The user data is placed in the email text body. Each line of the user data entry is braced
with the symbol “&”, such as: &my line 1 message&. The number of characters for each
line is limited to 200 characters. The maximum number of message lines is limited to 50.
For example, to send user data to serial port 2, enter the control command in an email
subject field:
&mySysName&myName&sset 2&
Then enter user data in an email body field:
&kill 45667 &
& lprint logfile &
Any messages that are not braced within “&” are not forwarded to user serial console port.
Figure 23 – Example of Sending Data to User Serial Console Port
