User’s Manual
Synaccess Networks, Inc.
www.synaccess-net.com
(760) 930 – 0473 Page 36 of 46
4.5 Serial Console Port Configuration Menu:
This section describes serial console port configuration and operating settings:
Serial Console Port configuration starts with the following menu:
************************************************************
* *
* *
* Serial Console Port Configuration Menu *
* *
* *
************************************************************
>
> 1) Set active serial console port.
2) Change serial console parameters.
3) Show serial console port status.
4) Quit and go back to previous menu.
Figure 25 – Serial Console Port Setting (Terminal Screen)
•
Option 1 – Set Active Serial Console Port:
Set a user serial port to active so that the Local Master Port becomes transparent to the
active port. However, even the active port is selected; you may or may not able to
communicate with the user port. You are only be able to operate the active serial port if
the port is unreserved (“open”), or reserved by you. But, if you logged in at
Administration level, you are able to overwrite user level privileges and communicate any
ports you select.
•
Change Serial Console Port Parameters:
Enter Serial Console port Configuration submenu.
•
Serial Console Port Status:
Display all serial consol port parameters.
> Serial Console Port Configuration Status
Port | Name | Baud | DB | P | SB | FlowCtrl | Owner | Status
-----+------------+--------+----+---+----+----------+------------+-------
M | Master | 9600 | 8 | N | 1 | none | Admin | On
1 | Undefined | 9600 | 8 | N | 1 | none | Open | Off
2 | Equip5 | 9600 | 8 | N | 1 | none | JohnW | On
3 | Undefined | 9600 | 8 | N | 1 | none | Open | On
4 | Undefined | 9600 | 8 | N | 1 | none | Open | On
5 | router2 | 9600 | 8 | N | 1 | CTS/RTS | Open | On
6 | Undefined | 9600 | 8 | N | 1 | none | Open | On
7 | Undefined | 9600 | 8 | N | 1 | none | Open | On
8 | Undefined | 9600 | 8 | N | 1 | none | Open | On
>Local Master serial is in Console mode.
>
>Enter "q" to quit or enter a port number (or M) to make changes:
Figure 26 – List of Serial Console Port Configuration Status (Terminal Screen)
