User’s Manual
Synaccess Networks, Inc.
www.synaccess-net.com
(760) 930 – 0473 Page 12 of 46
3 Access to the System
3.1 Factory Default Settings:
The system is shipped with Factory Default settings. The default settings for the Local Master serial
port are
: 9600, 8 data bits, no parity, 1 stop bit, and no hardware handshaking (Flow Control)
.
The default Administrator’s login name
“admin”
and the default password is
“admin”.
All existing
user accounts are erased if the system is recovered to the default settings. The default SNMP
Community string for public, private and Trap access is “
public
”.
There are two ways to restore the system to the Factory Default settings. The first method is to press
a push-button switch located on the front panel for 1 second. The second method is to select "Reload
Factory Defaults" from the Main Menu. The Main Menu can be viewed by running a terminal
emulation program such as Window’s Hyper Terminal or Telnet.
Upon the system startup, the terminal screen displays the following screen, as shown in the Figure 6.
If you do not see the screen as shown in the Figure 6, it is likely that the system is not in the default
state. Otherwise, your connection to the Local Master port is established.
Figure 6 - System Startup Screen
************************************************************
* *
* *
* Synaccess Networks Inc., Carlsbad, CA, USA. Copyright(c) *
* *
* System NP-08 *
* *
* *
************************************************************
HW:3.1 SW:4.1.1
>>DHCP is enabled (DHCP timeout is 8 sec).
>IP address fallback is enabled
>Netwotk initialization....
Network Interface is now UP
>DHCP OK
Timezone (fallback only) = 0h
IP Address: 192.168.0.109
Netmask: 255.255.255.0
Gateway: 192.168.0.1
>
>
>. !!! Important: a control command must proceed with the symbol "/"
> at the beginning of a command line input. To change it, type "/setup".
>
>Type "/help" for a list of commands.
>
