Pairing Settings
The Pairing tab indicates whether the SNAP Link adapter is paired with
another adapter, which is denoted by displaying the other
pair's SNAP
address.
State
This is the paired state. The value can be:
•
Simple Broadcast
–
Unit is in a reset state and is waiting to be set up.
•
Searching for Master
–
Unit is in multipoint mode and is searching
for
a master unit with which to pair.
•
Master
–
Unit is in multipoint mode and is the master. It is now willing to accept slave units.
•
Slave –
Unit is in multipoint mode, is a slave, and has paired with a master.
•
Ready to Pair – Unit is in point-to-
point mode and is looking for another unit with which to pair.
•
Paired – Unit is in point-to-
point mode and has been paired with another.
Address of Pair
When paired, this will be the device address the unit is paired with. If a slave, this will be the address of the
master. If a master, this field will be blank.
Time Between Status Messages
The number of seconds between pings. The device will periodically ping its partner to confirm connectivity.
Advanced Settings
The Advanced tab contains a single checkbox labelled Button Lockout. When
checked, the MODE button on the front
of the SNAP Link adapter will be
disabled. However, the MODE button can still be used to perform a reset,
putting the SNAP Link device back into
broadcast state.
14
SNAP Link
Summary of Contents for SNAP Link
Page 4: ......
